Marking packets to use a specific routing table is called policy routing throughout Mikrotik documentation and it has nothing to do with IPsec policies. The simplest way to achieve this is to add an /interface bridge without any member interfaces, and make it the gateway of the default route in a dedicated routing table for traffic which should only go via the VPN. But because IPsec policy matching, and eventual packet redirection to the IPsec SA, requires that the packets were routed the normal way first, you need that the normal routing always sends them somewhere. Then was a bit of a fight in till Disney+ was working, static DNS for the rescue on that oneĪs for the leaks, you have to make sure that while the VPN is down for any reason, packets are not routed the normal way via WAN. # PEER TUNNEL SRC-ADDRESS DST-ADDRESS PROTOCOL ACTION LEVEL PH2-COUNTġ DA ProtonVPN yes x.x.x.x/32 0.0.0.0/0 all encrypt unique /ip ipsec proposal> /ip ipsec proposal printġ name="ProtonVPN" auth-algorithms=sha256 enc-algorithms=aes-256-cbc lifetime=30m pfs-group=none
Please do not hesitate to contact us again if any additional information or assistance is needed.Ĭode: Select all /ip ipsec proposal> /ip ipsec mode-config printġ name="ProtonVPN" responder=no /ip ipsec proposal> /ip ipsec profile printġ name="ProtonVPN" hash-algorithm=sha256 enc-algorithm=aes-256 dh-group=modp4096,modp2048,modp1024 lifetime=1d proposal-check=obey nat-traversal=yes /ip ipsec proposal> /ip ipsec peer printįlags: X - disabled, D - dynamic, R - responderĠ name="ProtonVPN" address=x.x.x.x/32 profile=ProtonVPN exchange-mode=ike2 /ip ipsec proposal> /ip ipsec policy printįlags: T - template, X - disabled, D - dynamic, I - invalid, A - active, * - default
Unfortunately, Mikrotik routers do not support OpenVPN client connection, therefore, it is not possible to set up a ProtonVPN connection on it. By using ProtonVPN, you can be confident that your VPN tunnel is protected by the most reliable protocol.įor more information, please refer to the following page: ProtonVPN does not have any servers that support PPTP and L2TP/IPSec, even though they are less costly to operate. We use only VPN protocols which are known to be secure - IKEv2/IPSec and OpenVPN. With each connection, we generate a new encryption key, so a key is never used for more than one session. This means that your encrypted traffic cannot be captured and decrypted later if the encryption key from a subsequent session gets compromised. We have carefully selected our encryption cipher suites to only include ones that have Perfect Forward Secrecy. This means all your network traffic is encrypted with AES-256, key exchange is done with 4096-bit RSA, and HMAC with SHA384 is used for message authentication. We use only the highest strength encryption to protect your Internet connection.
0 kommentar(er)
